The GB 8101-87 Board Compression Hydraulic Overflow Valve is an industrial device designed to prevent the over-pressurization of a system by releasing the excess pressure. An important safety device for any hydraulic system, the valve is designed to open when a preset pressure, determined by the safe working pressure of the system, is reached.
The GB 8101-87 Board Compression Hydraulic Overflow Valve is of the board compression type, which means that when it opens, the pressure within the system is reduced until the valve closes. The valve consists of a steel body, a pressure regulating valve, and a pilot valve. The pressure regulating valve is connected to the steel body and can be adjusted to control the pressure at which the valve will open.
The GB 8101-87 Board Compression Hydraulic Overflow Valve must be installed on a flat, horizontally level surface. It is not recommended to be installed on a slope surface. The valve needs to be firmly bolted to the supporting structure and the connection needs to be watertight. It is important to install the valve in an area where it is protected from sudden impacts, since these can cause damage to the valve housing. The valve must be installed with the correct orientation, so that the pressure regulating valve is connected to the pilot valve.
When installing the GB 8101-87 Board Compression Hydraulic Overflow Valve, it is important to follow the manufacturers instructions. In general, the following steps must be taken: first, disconnect all power supply to the system. Second, make sure that all components are properly assembled and connected with the correct fasteners and gaskets. Third, mount the valve onto the support structure and connect it to the piping correctly. Fourth, connect the valve to the pressure regulating valve and pilot valve. Fifth, adjust the pressure regulating valve according to the systems specs. Finally, check the assembly and make sure that everything is properly connected.
The GB 8101-87 Board Compression Hydraulic Overflow Valve is a vital component of any hydraulic system and must be installed correctly and checked regularly. It is essential to follow the manufacturers instructions when installing the valve, and to check it regularly for any blockages or wear. An improperly installed or faulty valve can not only lead to safety problems, but can lead to costly damages to the system.
