Metal Cutting Machine Tool Universal Operation Rules
Metal cutting machine tools are widely used in metallurgical mining, hydropower, shipbuilding and other industry sectors. In order to ensure the safe operation of the machine tool, the machine tool manufacturer will provide corresponding operating regulations and safety regulations according to the characteristics of the machine tool.
In the operation of metal cutting machine tools, there are certain operating procedures and basic requirements. First of all, before the machine is started, the operator needs to check whether the machine is in good condition. For example, whether the various screws are tightened, whether the workbench and fixtures are properly installed and adjusted, and whether the lubrication components such as the lubricating oil slinger are normal. At the same time, it is necessary to carefully check whether there is any debris on the machine and whether the limit mark of each mechanical component is correct. All these checks must be done in order to avoid mechanical failure during the operation of the machine.
Secondly, after all the inspections are completed, start the machine and check whether the machine is running normally. At this time, it is necessary to pay attention to whether the feed current exceeds the normal bearing capacity of the machine, whether the sliding parts have obvious wear and whether the crash phenomenon occurs during the operation. If abnormalities are found during the inspection, stop the machine immediately, eliminate the fault or abnormalities, and check before operation again.
In the process of machine tool operation, operators are not allowed to conduct operation overloading or increase the speed too fast. In addition, in the operation of the machine, it is necessary to pay attention to the heat of spindle, slide surfaces and other parts. If the temperature increases abnormally, the machine should be stopped for cooling.
In addition to the above main points, it is also necessary to observe the operating rules of the machine tool. Such as whether it is necessary to wear safety tools such as gloves, safety goggles and so on, forbid to stand on the machine. In the course of operation, the operators should also pay attention to prevent the shortage of cooling fluid, the debris entering the mechanical components and the shielding of the electrical components in the unshielded environment.
In short, the safe use of metal cutting machine tools requires not only the awareness of operators, but also the implementation of corresponding operating regulations and safety regulations. All operators must strictly abide by the operating regulations and related safety production regulations when operating the machine, so as to ensure the normal operation of the machine and the safety of personnel.
