Cutting head and scrap cutting are important processes in the production of high-strength bolts and nuts. Cutting head refers to the cutting away of the head part of the pre-rolled raw material to obtain the required length. The scrap cutting is the subsequent process of cutting head, which cuts the excessive strip pieces in the end of bolt and nut into the Waste material.
Cutting head is an important process in the production of high-strength bolts and nuts. This process needs to use a high-precision equipment namely cutting machine, and the false operation in this process will cause the incorrect dimensions, greatly reducing the accuracy of the product and affecting the quality. Here to introduce the cutting head process of high-strength bolts and nuts.
1. Place the pre-rolled raw material in the lower die of the cutting machine. The upper die exerts pressure on the pre-rolled raw material to fix it in the lower die.
2. The upper die starts to move downwards and cuts into the pre-rolled raw material. The operator sets the required cutting length according to the size of the product in the cutting machine. The upper die continues to move downwards and cuts the pre-rolled raw material into the finished product.
3. At the same time, the finished product falls into the finished product receiving tank. After being collected from the tank, it undergoes the next process.
Scrap cutting is one of the important processes in the production of high-strength bolts and nuts. It is the subsequent process of cutting the head, and it is used to cut the excessive strip pieces in the end of the high-strength bolts and nuts into the waste material. The steps of scrap cutting process are as follows.
1. Place the bolts and nuts cut off by the cutting head device into the machine.
2.The upper die of the machine exerts pressure on the bolts and nuts and fixes them in the lower die.
3. The upper die begins to move downwards and cuts into the bolts and nuts. The operator sets the required cutting length according to the size of the product in the scrap cutting machine. The upper die continues to move downwards and cuts the bolts and nuts into the specified length.
4.The finished product falls into the finished product receiving tank, and it is collected from the tank to undergo the next process.
In conclusion, the cutting head and scrap cutting are important processes in the production of high-strength bolts and nuts. The cutting head is used to cut the pre-rolled raw material into the required length, and scrap cutting is used to cut the excessive strip pieces in the end of the bolt and nut into the waste material. Therefore, the correct operation of these two processes can ensure the accuracy and quality of the high-strength bolts and nuts.
