EN 10113-3:1993 Hot Rolled Products in Weldable Fine Grain Structural Steels Chemical Composition and Mechanical Properties
Scope
This European Standard applies to hot rolled products in weldable fine grain structural steels which are produced in the form of sheets, plates, strips, and wide flats with a minimum thickness of 3mm and, unless otherwise specified a maximum thickness of 250mm.
Steel Grades and Delivery Conditions
The steel grades and delivery conditions relating to BS EN 10113-3: 1993 are:
S275N,S275NL,S355N,S355NL
Delivery
The delivery condition for products in accordance with EN 10113-3 is normalized.
Chemical Composition
The chemical composition of the steel grades in accordance with BS EN 10113-3: 1993 shall be as specified in Table 1:
Table 1 - Chemical Composition of Steel Grades
Grade Max
C Si Mn P S N Al 0.22 0.40 0.45 0.020 0.010 0.015 0.03+
Mechanical Properties
The requirements relating to mechanical properties of the steel grades in accordance with BS EN 10113-3: 1993 shall be as specified in Table 2:
Table 2 - Mechanical Properties of Steel Grades
Grade Tensile Strength
Rm [MPa] Yield Strength
Re H [MPa] El.
Yield Strength
ReH [MPa] Impact V [J] Charpy
U-V-UL [J] S 275N 270 - 430 40 270/360 20 27 S 275NL 270 - 430 40 270/360 27 27 S 355N 450 - 630 40 450/530 20 27 S 355NL 450 - 630 40 450/530 27 27
Conclusion
This standard applies to hot rolled products in weldable fine grain structural steels which are produced in the form of sheets, plates, strips, and wide flats with a minimum thickness of 3 mm and, unless otherwise specified a maximum thickness of 250 mm. The chemical composition and mechanical properties are specified for the S275N,S275NL,S355N,S355NL grades of steel produced in normalized delivery condition. The chemical composition is according to Table 1 and the mechanical properties are according to Table 2.