Operating procedure of JF2004 coating sand spraying Machine
1. Preparation before operation
(1) Before starting the coating sand spraying machine, carefully inspect the machine and check whether all related parts are in optimal condition and whether all fastening parts are tightened.
(2) Before starting the machine, lubricate all lubricating points and all components of the transmission and various parts of the machine, including oiling, screw nut fastening and other steps.
(3) Check the connection conditions of the important pipelines and the tightness of the connectors.
(4) Make sure the machine is in a stable condition.
2. Start the coating sand spraying machine
(1) Confirm that the operation panel is in the shutdown state and the protective cover is properly covered.
(2) Connect the power supply, turn on the switch, and check whether the speed of the electric vibrating screen mesh is normal.
(3) Open the emergency button.
(4) Start up the debugging device, and the machine is running correctly.
3. Operation process
(1) The operation panel is turned to automatic mode.
(2) Put the material into the correct position.
(3) Check the corresponding numbers and positions on the operation panel to confirm that all procedures are correct.
(4) Start the automatic process, press the start button, and observe the operation until the sand becomes smooth.
(5) When the equipment is in normal operation, pay attention to adjust the required amount of sand through the throttle and valve.
(6) Cut off the power, turn off the machine, and make the necessary checks.
4. Restrictions on operation
(1) Do not open the protective cover or touch the inside of the equipment without authorization.
(2) Do not feed excessively and pay attention to cleaning up the sundries at any time.
(3) Pay attention to the observation during the operation of the sand spraying machine.
(4) Check the protective cover regularly to see if it is in good condition.
(5) Pay attention to check the stability of the equipment at any time.
(6) During the operation of the sanding machine, operators shall not perform related work to prevent the machine from being damaged due to overload.
5. Shutdown of coating sand spraying machine
(1) Turn off the power switch of the equipment and make corresponding operations according to different types of equipment.
(2) Close the emergency button.
(3) If necessary, clean the interior of the equipment and clean it.
(4) Fix the protective cover and check whether the equipment is in good condition.
6. Maintenance of coating sand spraying machine
(1) Check frequently whether the sand spraying speed is normal, whether the pressure is constant, and whether the temperature is normal.
(2) Check if the connected nuts or joints of the various parts are loose or loose.
(3) Regularly clean up the sundries of the sand spraying machine, maintain the equipment in a good and clean environment, and check whether the equipments of the sand spraying machine are in good condition.
(4) Pay attention to check the protective cover regularly to see if it is in good condition.
(5) Regularly lubricate all parts of the sand spraying machine and keep all fastening parts tight.
(6) Clean up the sundries in the equipment and in the space where the sand spraying machine is installed to keep the surrounding environment clean.
The above is the operating procedure of JF2004 coating sand spraying machine. During the use and maintenance of the equipment, operators should pay attention to the cleanliness of the equipment and always keep the equipment in a high working efficiency state.
